Instructions for Replacing Slats and Shorten Blinds

Instructions for Replacing Slats

• Remove the bottomrail plugs to reveal the knotted lift cord
• Undo the knot and pull the lift cord out from the front of the blind. Only pull out the lift cord as far as necessary to release the slats you are removing
• Replace slats
• Restring the blind. Alternate the lift cord from left to right on each ladder rung as you work your way down the blind
• Insert the lift cord through the bottomrail hole and tie a knot. Make sure that the lift cords are even and that the bottomrail hangs straight
• Replace the bottomrail plugs. Use a rubber mallet or hammer to keep from marking the plugs

Instructions to Shorten Blinds

• Remove the bottomrail plugs to release the string ladders and reveal the knotted lift cord. Undo the knot and pull up lift cord enough to release the slats you need to remove
• Remove the bottomrail and slats necessary to shorten the blind
• Determine the desired length and insert the bottomrail into the last ladder rung
• Cut the string ladder above the rung that hangs below the bottomrail.. You should have enough ladder hanging to be able to insert these strings into the route holes on the bottom of the bottomrail
• Insert the lift cord through the bottomrail hole and tie a knot. Make sure that the lift cords are even and that the bottomrail hangs straight
• Adjust to the desired length by lowering or raising the knot in the lift cord. You may also insert more or less of the ladders in the bottomrail route. Do not try to adjust the length by pulling on the lift cord
• Replace the bottomrail plugs. Use a rubber mallet or hammer to keep from marking the plugs